This not only ensures you are taking the right steps to protect both workers and property but that you can also meet the necessary health and safety compliance standards. Assuming that the appropriate equipment has been chosen and detectors are installed in the right places, there is no doubt that training and education helps to reduce false fire alarms. BS 5839-6: 2019 section 25.1 also states that the testing of a fire alarm can normally be carried out by the occupier of the premises. BS 5839-6: 2019 section 25.1 states that the testing of a fire alarm does not require any specialist knowledge, and can normally be carried out quite easily. In section 25.2 it states that all fire alarm systems in commercial premises need to be tested weekly to ensure that there has not been any major failure, and that the fire alarm system is in working order. In addition to the three major threats discussed above, there is a range of other security risks that construction sites face. However there’s no one correct type, as it depends on the level of security and type of activity taking place on your particular construction or building site.

In smaller premises, it is acceptable to test just one location each week – so for example within a premises where there are a small number of outstations, these could all be tested over a two month period in rotational order. In the majority of the above cases the following changes helped to remedy the number and occurrence of false alarms. They test for smoke, heat and changes in the environment but that also means they pick up other elements such as steam, cigarette smoke and aerosol sprays. Do I need to be trained to test fire alarms? Competence of a fire alarm servicing company or organisation can be assured by the use of companies registered with organisations providing third party certification or accreditation, such as British Approvals For Fire Equipment (BAFE). The first step in obtaining construction site security should involve an on-site risk analysis where a security company should come on-site to assess your current security measures, identify weak points and suggest improvements.

A false fire alarm is where no explanation can be given as too why the detector has activated, requiring further investigation by the fire alarm maintenance company. Noisy construction work or crowds of people can make difficult conditions for a sound only fire alarm to be fully effective. The fire alarm system you choose really depends on the nature of work on your site and how temporary the site is. Although the requirement for this work is to be done annually, the works detailed may be carried out over the course of two or more service visits during a 12 month period. However, it may be appropriate for a competent person to provide initial instruction in the testing of a fire alarm system for this to carried out diligently. However, https://www.detecter.co.uk/fire-systems/ a responsible person (or person appointed by the responsible person) can carry out testing of the fire alarm system after being trained to do so correctly. When someone detected a fire, they would crank the handle that was attached to the fire alarm box, which would then send the details of the fire alarm box number to a central alarm station.

We don’t do this, but can understand this decision given the number of false alarms we receive every year. When replacing detectors, consideration should also be given to the best location considering local (potentially changing) false alarm sources. It is important to note that if the fire alarm is linked to an alarm receiving centre (ARC) that the ARC is contacted immediately before and immediately after the weekly fire test, to ensure unwanted alarms are avoided and that the fire alarm signals are received appropriately. In premises in which the location of the master station is such that the audible fault warning signal could go unnoticed for longer than 24 hours, a special check should be carried out each day to confirm that either the equipment indicates normal operation, or that any fault indication is receiving necessary attention. Helps to draw their attention to the fact that they are about to lift the cover on a fire alarm activation point. The second type is an addressable fire alarm system, where a detected fire (whether by automatic fire detection systems or the activation of a fire alarm manual call point) is registered on the fire alarm control panel as a specific location or address within a zone, such as via an automatic smoke detector in the ground floor boiler room, or a fire alarm manual call point by the ground floor rear fire exit.

If you have any issues pertaining to in which and how to use https://www.detecter.co.uk/fire-systems/, you can contact us at our webpage.